How to decorate an exterior, and in which order.

If you have fascias and soffits to paint, do these first.
It’s always best to remove the gutters so you can paint behind them properly; this is where they can start to rot. It’s also a good time to clean out the gutters and wash them before putting them back.
If the fascias and soffits are dirty, give them a wash down first, and then dry them off. Now rub them down, remove any flaking paint. If you have any bare wood paint them with a primer.
Next undercoat them with a suitable undercoat, then you can topcoat them with a gloss.
Obviously if your fascias and soffits are stained, you would simply do as above but paint them with two or more coats of stain rather than primer, undercoat and topcoat.

Next if your walls are painted, paint these next.
Before you jump straight in, rub your hand over the wall, look at your hand; does it have a powder on it? If so this means the paint already on the wall has been affected by the sun and weather. You will need to ‘stabilise’ the walls first, this sounds dramatic and as if the walls are about to fall down, but it isn’t. All you need to do is buy some ‘stabilising solution’ and brush it onto the walls. What this solution does is ‘stick’ and seals the old paint giving you a good surface to paint onto.
Continue reading Order of painting an exterior of a house

We have updated the portfolio page today to include a photograph of a recent dining room we decorated in Shoeburyness.

View our portfolio pages.

This tip applies to both interior and exterior panelled doors, it doesn’t matter how many panels there are, whether it be a 1, 2, 4 or 6 panelled door, the principle is the same.

The first job is to remove the door furniture such as handles, letterbox, knocker etc, now cover the floor. The next job is to remove any loose paint as well as any dirt and grime. Next rub the door down, depending on the surface you are painting over and its condition 80-grit sandpaper will be fine. Rub down, going in the direction of the grain, if you have an internal ‘grain effect’ door be careful not to rub too hard!

Once you have ‘keyed’ the surface with the sand / glass paper dust off the surface. If the door has any bare wood showing you will need to use the appropriate primer. Once the primer is dry you can paint the door with a suitable undercoat, finally the finish coat (gloss or satinwood etc) of your choice.

So what order do I paint the panel door?

OK, here is the order to paint your panel door:

1. Paint the door edge, you should always paint the edge you will see if the door is open. Number 1 in diagram. If it is an exterior door you should also paint the top of the door, and the bottom if you can.
2. Paint the panels. Numbers 2-7 in diagram.
3. Paint the top mullion and rail, numbers 8 and 9 in diagram, and work through all mullions and rails finishing with the bottom rail. Number 14 in diagram.
4. Finally paint the two stiles. Numbers 15 and 16 in diagram.
5. If you are using gloss, check to ensure the paint hasn’t run off the panels, if there are runs simply brush them out with a dry brush.
6. You should now have a newly painted door!

NOTES:

Stiles: vertical parts
Mullion: vertical parts between panels
Rails: horizontal parts
Panels: moulded ‘inset’ shaped areas