coloured stripe


Painting, decorating and home improvement tips blog

How to fit door handles or door knob

Posted by Adrian
May 24th, 2020

How to fit door handles or door knob

Once you have fitted a lock such as a mortise sash lock or a cylinder rim lock or are just simply replacing the handles. This post will explain how to do it, it is a fairly simple task and should’t take to long. This post assumes the lock is already fitted to the door and you just need to fit the handles or you are just replacing handles. If you are fitting a new door, you will need to fit a lock first.
Door Handle drawing

As always, you will need to gather the tools you require together before starting the job, you will need:

  • A door handle or knob set
  • A drill
  • A small drill bit
  • A screwdriver
  • A small level
  • A junior hacksaw (possibly required)

Fitting the door handle or door knob

In the door handle pack you should have two handles, fixing screws and a square spindle. Open the pack and put to one side.
Firstly take the spindle and put it through the lock, then take one handle and place it on the spindle.
Now take the level and upright the handle by placing the level on the side of the handle, that is, of course as long as the handle doesn’t have uneven sides or it is a door knob.
When the handle is upright and level, hold it with one hand while you drill two pilot holes, do this for example for the top left and bottom right holes. Then screw the fixing screws in and then drill the final two holes for this handle or knob.

Now take the other handle and try it on the spindle, the spindle maybe too long and requires cutting. Put the second handle on the spindle and see how far the back of the handle is away from the door, you will need cut this amount of the spindle.

Once the spindle has been cut you can fit the second handle, do this the same way as you did the first one. Once all the screws have been screwed in you can try the handle, if the handle stays down without returning to its original position, try loosening the handle fixing screws slightly, this should help. If it doesn’t help, remove one handle and see if the spindle is rubbing on the door where the spindle goes into the lock, if it is remove the spindle and chisel away where it is rubbing, refit the spindle and handle and try again.

Finally, clean off and finger marks off the handle with a soft cloth.

Tags: , , , , , ,
Posted in Home Improvements | No Comments »




Leave a Comment




Top

My Paintbrush logo