How to paint a radiator

To paint a radiator firstly turn it off and let it go cold if it has been in use. Once the radiator is cool your ready to begin.

Firstly give the old paint on the radiator a ‘key’ for the new paint to adhere to, basically this means give the radiator a light rub down with a fine to medium grit abrasive such as sand or glass paper. You could also use wet and dry.

Next, dust off the radiator or wipe it over with a damp cloth to remove and dust. You are now ready to start painting.

It is advisable to lay a dustsheet under the radiator to catch any spills, splashes etc.

Where to start?

I normally paint the ends first, painting around the bleed valve end then the other end.
Load the brush with paint and paint the first three or four flutes (the indented parts) at the top and the bottom ensuring they are covered well.

Next paint the first few flutes from top to bottom, then with an unloaded brush, brush from top to bottom spreading the paint over evenly.

Depending on how big the radiator is you can paint all the flutes and then the top and bottom of the radiator. If the radiator is big or if you work slowly it is better to do a few flutes and then work the top and bottom along as you go.

When you have worked your way along the entire length of the radiator go back and check for any runs, normally at the bottom of the flutes, if there are any runs simply brush them out with an unloaded brush.

Finally, stand back and admire your work!

Please note that when you do turn the radiator on again it will give off a smell, this is the paint and is normal, the smell will go after the radiator has been on a few times and the paint is fully cured.

Tile calculator

Today sees the launch of our new calculator, the Tile Calculator.
The easy way to work out how many tiles you need. Any tile size can be calculated.

As simple and as quick to use as the other calculators within our website. Simply fill in the tile dimensions and the surface area to be tiled, decide on the percentage you want to add for breakage and waste from 0, 5, 10 or 15%.
Once you have done that then hit the calculate button, simple!

You can try it out here: https://www.propertydecorating.co.uk/tile_calculator.php

This calculator is as simple and as quick as all the other calculators. We have also included a feet to metre converter.

As always, we welcome your comments.

Using our Tle calculator is easy

Decoration or Preparation?

Preparation is key

A good decorating job consists of 90% preparation and 10% decoration, get these percentages around the wrong way, and you’ll know about it.

Taking the time to prepare before you decorate will pay dividends by giving you a far superior finish.

Things such as removing old wallpaper, washing things down, dusting off all take time but need to be done and done right.

For ceiling and walls

Remove any old wallpaper first. Stick back any loose paper if you just want to paint over it.
Make sure any loose plaster is rectified; fill holes and cracks.
Remove any old rawl plugs and fill the holes.
Ensure filler is sanded down properly and not left high, as it will show.

Woodwork

Make sure you rub down woodwork before painting it.
Use a suitable primer on any bare wood, then undercoat it and then topcoat it.
If you topcoat straight over topcoat and not give the surface a key first the topcoat applied will easily chip or scratch off.

General

Let new plaster completely dry out before decorating.
Deal with any damp problems at source rather than just cover it up.
Remove any mould that may of grown and treat the affected area.

Remember, preparation is key. Do it well and it will show in the finished job, do it badly and you will see it forever!

Get a professional in if you are unsure what to do or simply don’t want to take the time to “prep for you dec”.